FREE SHIPPING OFFER

rwc_hs2_800.jpg

REAL WORLD CYCLING
SUSPENSION PRESS TOOL HANDLE SET 2
DESIGNED AND MANUFACTURED IN THE USA
 
SPECIALIZED REDUCED-SIZED 5MM DIAMETER THREADED ROD FOR SMALLER BEARING SIZES

 
 
This is the same basic design as our "Handle Set 1" only with a smaller diameter threaded rod (5mm) to allow a full pilot to be used in removing and installing suspension bearings that have an inner race ID that is too small for an 8mm threaded rod.  When used with our RWC 5mm bore bearing guides, precision alignment is obtained to allow for damage-free removal and installation of suspension bearings.
 
A full sized hub press is unwieldy for most suspension bearing jobs.  On the other hand, "winging" it with bolts, washers, and sockets often leads to misalignment problems and frustration.  That's where the RWC Suspension Bearing Handle Set comes in.  The miniature handle set, and the fact that neither one is permanently attached to the threaded rod, allow access to the tight spots that suspension bearings tend to be tucked into.  A 5mm x 6-inch threaded rod is provided for longer spans along with an additional 5mm x 4-inch rod for tighter quarters.  Both rods have special leading "bullet" guides to eliminate cross-threading.  When used with the proper guides for suspension bearing removal and installation, this tool makes the job much easier.  DESIGNED SPECIFICALLY FOR BEARING GUIDES WITH 5MM BORES.
 
Designed and manufactured in the USA.  
 
$79.00
 

Qty
 

 
CAN ALSO BE USED TO PRESS BEARINGS INTO 5MM QUICK-RELEASE HUBS.
 
 
 


 

Click to follow us on Facebook!