A full sized hub press is unwieldy for most suspension bearing jobs. On the other
hand, "winging" it with bolts, washers, and sockets often leads to misalignment problems and frustration.
That's where the RWC Suspension Bearing Handle Set comes in. The miniature handle set, and the fact that neither
one is permanently attached to the threaded rod, allow access to the tight spots that suspension bearings tend to be tucked
into. A 6-inch threaded rod is provided for longer spans along with an additional 4-inch rod for tighter quarters.
Both rods have special leading "bullet" guides to eliminate cross-threading. When used with the proper guides
for suspension bearing removal and installation, this tool makes the job much easier. ALSO WORKS WITH RWC NEEDLE BEARING
Designed and manufactured in the USA.